Troubleshooting; Specifications - Mercury M48 GT Owner's Handbook Manual

8. TROUBLESHOOTING AND SPECIFICATION

TROUBLESHOOTING

You can inspect the scooter using the checklist below before consulting your dealer. If you cannot solve
the problem by yourself contact your dealer.
Symptom
The scooter will not switch on.
The scooter switches on, but the
scooter will not move.
The scooter appears slow.
The seat turns when in operation
The tiller handlebar appears loose
Scooter will not drive and the left
hand panel on the battery gauge
will flash a sequence code.
Mercury M48GT Specification
Dimensions
(L x W x H)
Weight With battery: 168kg / 370lb
Without battery: 116kg / 255lb
Battery 2No. 12V 75ah (100ah option)
Motor
Control system
Drive system Direct drive to the rear wheels
Wheeltech M48 GT electric scooter
Owner's Handbook
Remedy
• Recharge the batteries.
• Check / reset the circuit breaker in the scooter.
• Check the battery and loom connections.
• Ensure there is enough power in the batteries. If not, recharge the
batteries.
• Ensure the freewheel lever is engaged in the DRIVE position.
• Check the battery power level and recharge.
• Check the speed dial is not set to slow, and that indoor / outdoor
switch is set to the faster setting (if applicable).
• Slowly rotate the seat until it drops in to place and is secure
• Tighten the tiller adjustment handle to secure the handlebar.
• Ensure the wigwag paddle is released.
• Switch the scooter off and on using the ignition key.
• Recharge the batteries.
• If the problem persists, contact your dealer.
1560 x 740 x 920mm
61½" x 29" x 36¼"
750W
By wigwag paddle
(with transaxle)
Mercury M48GT Specification (cont'd)
Brake system
Front tyre
Rear tyre
Charger
Max. speed
Climbing angle
Cruising range
Max. user weight
Electromagnetic, with
Secondary cable brake
2No. 4.00-5 grey pneumatic
2No. 4.00-5 grey pneumatic
8A 24V DC
8mph / 12.8kph
10° / 1 in 6 maximum
30 mile / 48km
250kg / 39 stones
Part Code: Z40962-00
Page 19 of 19