Starting, Driving And Stopping - Mercury M48 GT Owner's Handbook Manual

• Starting and Driving
1. Ensure the seat is installed properly.
2. Ensure the tiller has been secured properly.
3. Fold down the arm rests so you can rest your arms comfortably on them.
4. Turn the ignition on.
5. Check the battery gauge to see whether there is enough battery power for your journey. If you
have any doubt about the remaining power, recharge your batteries before departure.
6. Set the speed dial to a position you feel safe and comfortable with.
7. Check the wigwag paddle works correctly
8. Ensure the electromagnetic brake works correctly.
9. Before driving, ensure it is safe to do so in the environment around you.
F Attention
1. Do not push both right hand and left hand sides of the wigwag paddle simultaneously. This might
leave you unable to control your scooter.
2. Do not turn the ignition off while driving as this will lead an emergency stop and possible risk of
accident, injury and damage.
3. Do not set to the highest speed whilst driving indoors.
4. Do not adjust the speed dial whilst driving. A sudden change in speed may cause damage to you
and other and may cause damage to your scooter.
5. Do not place magnetic devices near the controller or tiller area as this could affect the safe
operation of your scooter,
6. Do be careful whilst driving in heavy traffic or crowded areas.
7. Whilst reversing the vehicle, be aware of people or objects behind you.
Stopping
Release the wigwag paddle completely. The vehicle will automatically brake and stop. If required use the
hand brake to assist braking.
F Attention
Stopping distances will vary with your speed. Therefore begin braking as early as you can.
While parking your scooter, ensure you park on flat ground and then turn the power off at the ignition
before disembarking.
Wheeltech M48 GT electric scooter
Owner's Handbook
5. DRIVING ON THE ROAD
Part Code: Z40962-00
Page 12 of 12