Troubleshooting & Specification - Mercury Monami Owner's Handbook Manual

8. TROUBLESHOOTING AND SPECIFICATION
8.1 DISASSEMBLING THE SCOOTER
The scooter can be disassembled into five pieces, the seat (weight 15.3kg), the front section (weight 21.8kg),
the rear section (weight 17.9kg), and two batteries (weight 11.2kg each) without any tools. Please follow the
steps and photographs below:
1. Switch off the scooter, unscrew
the seat hand wheel and remove
seat. Be careful not to let the seat
post drop when removing.
4. Undo the Velcro straps and
remove batteries.
7. Unplug the front-to-rear
harnesses. On the Vitesse 8 only,
remove the 'R' clip and pin
attaching the rear cable brake.
Wheeltech Monami and Vitesse electric scooters
Owner's Handbook
2. Lift up the rear shroud to
remove. Disconnect the rear lamp
connector to allow this.
5. Loosen the tiller adjustment
knob and fold down the tiller and
retighten knob.
8. Press down on the rear bumper
to pivot the scooter's rear section
upwards until the rear section is
standing vertically on its rear
bumper.
3. Disconnect the batteries by
disconnecting the two red
connectors and two black
connectors.
6. Remove the lock pin located to
the rear of the seat post and
between the batteries.
9. Lift the front section until the
lower pegs are no longer in the
curved locking brackets. Carefully
lift the front section away from the
rear section.
Part Code: Z40961-00 (Rev B)
Page 19 of 24