System Connections - Kenwood D-S300 Instruction Manual

System connections

Caution:
4
Do not plug in the power lead until all connections are com-
pleted.
Make connections as shown below.
When connecting the related system components, refer also to the
instruction manuals of the related components.
Caution regarding placement
To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer
dimensions including projections) equal to, or greater than, shown below.
Left and right panels: 10 cm
75 coaxial cable with RCA PIN.
(Commercially-available)
L
R
LINE OUTPUT
Audio cord
1. Connect all cords firmly. If connections are loose there could be loss of sound or noise produced.
2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging/unplugging
Notes Notes
connection cords without removal of the power cord can cause malfunctions or damage to the unit.
Rear panel: 10 cm
Commercially-available
optical fiber cable
TEXT
OPTICAL COAXIAL
DIGITAL OUTPUT
Remove the protection cap when using
the DIGITAL OUTPUT (OPTICAL) jack.
CD
L
R
The above illustration is simply an example.
The actual connected equipment may vary depending on the sales region.
Malfunction of microcomputer
If operation is not possible or erroneous display appears even
though all connections have been made properly, reset the
microcomputer referring to "In case of difficulty".
Digital component (MD, DAT, etc.)
(OPTICAL)
DIGITAL INPUT
(COAXIAL)
SISTEM
CONTROL
System control cord
SYSTEM
CONTROL
AV CONTROL CENTER (sold separately)
or receiver (sold separately)
AV CONTROL CERTER
AC 110- AC 220-
120V 240V
To AC outlet
To wall AC outlet
D-S300 (En)