Fitting The Machine Undercounter - IFB Neptune Dx Instruction Manual

The indoor fuse current value should be 10-16 A.
Your machine is set according to 220-240 V. If the mains voltage in your location is 110 V, connect a
transformer of 110/220 V and 3000 W inbetween. The machine should not be plugged in during
positioning.
Always use the coated plug supplied with your machine.
The machine's electrical cable should be replaced by an authorised service or an authorised
electrician only. Failure to do so may lead to accidents.
In order not to cause an electric shock, do not unplug when your hands are wet.
For safety purposes, always make sure to disconnect the plug when a wash programme is finished.
Running in low voltage will cause a decline in washing quality.
When disconnecting your machine from the mains supply, always pull from the plug. Never pull the
cord itself.

Fitting the machine undercounter

If you wish to fit your machine undercounter, check whether you have sufficient space under your
countertop and whether the wiring-plumbing is suitable to do
the countertop is suitable for fitting your machine, remove the worktop as shown in the illustration.
Warning:The stand part which we will settle our machine under it by removing its worktop has
to be stable in such a way not to allow balance disorder.
To remove the worktop, remove the screws that hold the worktop which are located at the rear of the
machine; then push the front panel 1 cm from the front side towards the rear and lift it.
so.1
10
If you decide that the space under
2