Delay Time For The Centre Speaker; Phase For Sub Woofer Output; Storing Your Setting Of The Crossover Network/Delay Time; Surround Processor Control Setting - Kenwood Z910DVD[K] Instruction Manual

10.Delay Time for the Center Speaker
Adjust the delay time for center output.
Display and setting:
"CNTR DTA" : 0.0feet/0.5feet/1.0feet/1.5feet/2.0feet/2.5feet/
3.0feet/3.5feet/4.0feet/4.5feet/5.0feet
NOTE
• You cannot operate when the "PCM Center" is set to "OFF"
(page 29) <When playing with the 2ch PCM signal>.
• You cannot operate when the "Multi CH" is set to "2/2" or
"2/0" (page 29) <When playing with multi-channels>.

11.Phase for Sub Woofer Output

Adjust the phase for Sub Woofer output.
Display and setting:
"SW Phase" : Normal (0°) / Reverse (180°)
NOTE
You cannot operate when the "Sub Woofer" is set to "OFF"
(page.29).
12.Storing Your Setting of the Crossover
network/Delay time
Press the #1 - #6 button for at least two seconds.
Recalling your settings of the Crossover network/Delay time
Press the #1 - #6 button for the desired crossover network and
delay time setting.

Surround Processor Control Setting:

Adjust various parameters of sound quality.
1
Press the Q button for at least one second to enter the control
mode.
2
Selecting mode
Press either the FM or AM button.
Each time the button is pressed, the adjustment mode will
change.
Please refer to the following for the contents of the
adjustment modes.(Items 1-10 can be adjusted in this
Adjustment mode.)
3
Adjust each mode
Press the 4/¢ button.
Please refer to the following for the adjusting values.
4
Press the Q button to end the control mode.
NOTE
When the Noise sequencer is turned ON, only item 10 can be
adjusted.

1.Recalling the Kenwood Preset Sound

You can recall the best audio setting preset for different types
of the music.
Display and Setting:
"FLAT" / "POPS" / "ROCK" / "DANCE" / "VOCAL" /
"CLASSIC".
NOTE
• "User" displays each item when it's adjusted.
• Not available during the Dual zone system is on.
— 27 —