Audio Control Setting; Bass Centre Frequency; Bass Level; Bass Quality Factor - Kenwood Z910DVD[K] Instruction Manual

Audio Control Setting:

Adjust various parameters of sound quality.
1
Press the AUD button for at least one second to enter the
control mode.
2
Selecting mode
Press either the FM or AM button.
Each time the button is pressed, the adjustment mode will
change.
Please refer to the following for the contents of the
adjustment modes.(Items 1-13 can be adjusted in this
Adjustment mode.)
NOTE
Source tone memory
Each source (DVD, TV(AUX), FM, AM, and external disc) has its
own memory in which to store the bass, middle, treble and N-F
level settings.
The settings made for a particular source are then recalled
automatically whenever you use that source ( for example, FM
mode uses the tone settings made for FM, AM for AM, etc.).
3
Adjust each mode
Press the 4/¢ button.
Please refer to the following for the adjusting values.
4
Press the AUD button to end the control mode.
NOTE
• Determining the parameters in the audio control setting would
clear all the adjustments made in the System Q and they are
replaced with the values in the audio control setting.
• The following parameters can be set when the System Q
function on the menu settings is ON.
Bass center frequency, bass quality factor, bass extend, middle
center frequency, middle quality factor, and treble center
frequency.
1.Bass Center Frequency
Adjust the center frequency of the bass.
Display and setting:
"Bass FRQ" : 60 / 70 / 80 / 100 (Only when the bass quality
factor is set to 1.00, 1.25 or 1.50) / 150 (Only
when the bass quality factor is set to 2.00) Hz.

2.Bass Level

Adjust the bass level.
Display and setting:
"Bass" : - 9 – 0 – + 9

3.Bass Quality Factor

Adjust the Bass quality factor.
Display and setting:
"Bass Q" : 1.00 / 1.25 / 1.50 / 2.00

4.Bass Extend

Switch the Bass Extend mode on/off.
Display and setting:
"Bass EXT" : ON / OFF (When the bass extend mode is set to
on, low frequency response is extended by 20%.)
— 19 —