Table of Contents
Advertisement
drIVer replaceMent
1. Disconnect the air supply.
2. Loosen screw and nut with a 8 mm spanner wrench
and a 4 mm Allen wrench. (See Figure 16)
3. Remove the magazine assembly. (See Figure 17)
4. Loosen the set screw with a 3 mm Allen wrench to
unlock the adjusting rod.
PAGE 8 OF 11
operatIng InstrUctIons contInUed
Figure 16
Figure 18
Spring Pin
Figure 20
5. Slide the linkage mechanism and adjusting rod
simultaneously from the collar. (See Figure 18)
6. Loosen the screws with a 3 mm Allen wrench.
(See Figure 19)
7. Take off the spring pin with a hammer and 6 mm
straight rod. (See FIgure 20)
Figure 17
Figure 19
Magazine
Assembly
0513 IH-1027
Advertisement
Table of Contents
