Table of Contents
Advertisement
11. Install the nose cone using foam safe CA
glue, 5-minute epoxy, or contact adhesive.
12. Locate the Vertical Fins and connect the
lights with the plugs making sure to match
the polarity.
13. Use 5-minute epoxy to install the Vertical
Fins. Be sure to push the light wires all
the way into the fuselage so they do not
interfere with the fit the Vertical Fins.
14. To install the drop tanks, push them into
the matching tabs on the bottom of the
wing. They are removable for transpor-
tation. You may glue the tanks on for a
tighter fit.
15. Connect your 7-channel receiver to the
servo wires at the rear of the cockpit open-
ing.
16. Ailerons = Ail
17. Elevator = Ele
18. Rudder = Vector 3 and Steering
19. Gear = Retractable Landing Gear
20. Throttle = Throttle
21. Flap (Aux1) = Vector 1
22. Aux = Vector 2
7
Advertisement
Table of Contents
