Table of Contents
Advertisement
35. Select PROG.MIX1 from the radio menu.
Set the mix for ELEV to FLAP. Make sure
that the rates are both at -100% and that
the switch is set to MIX. There should be
no offset for this mix.
36. Select PROG.MIX2 from the radio menu.
Set the mix for ELEV to AUX2. Make sure
that the rates are both at +100% and that
the switch is set to MIX. There should be
no offset for this mix.
37. Select PROG.MIX3 from the radio menu.
Set the mix for AILE to FLAP. Make sure
that the rates are both at -100% and that
the switch is set to ON. There should be
no offset for this mix.
38. Select PROG.MIX4 from the radio menu.
Set the mix for AILE to AUX2. Make sure
that the rates are both at -100% and that
the switch is set to ON. There should be
no offset for this mix.
39. On LOW RATES the Ailerons should
move 1/2" in both directions. The Thrust
Vector units should move in the same
direction as the Ailerons.
NOTE: When the Ailerons are in their neutral
position the Thrust Vector Nozzles should be
in their neutral positions also. If they are not
you must adjust them mechanically by screw-
ing or unscrewing the ball link connector to
achieve a neutral position.
10
Advertisement
Table of Contents
