English such as in the presence of flammable liquids, gases or GENERAL SAFETY RULES dust. The tool create sparks which may ignite the dust or fumes. WARNING ■ Objects struck by the lawn mower blade can cause severe injuries to persons. Thoroughly inspect the area To reduce the risk of injury, the user must read and where the machine is to be used and remove all rocks, understand the operator’s manual.
English area to be mowed. ■ Allow engine to cool before storing in any enclosure. ■ Never operate the machine with defective guards ■ To reduce the risk of fire, keep the engine, muffler, and or shields, or without safety devices, for example petrol storage area free of grass, leaves, and excessive deflectors and/or grass collector, in place.
■ If any parts are damaged or missing, please call your cause severe burns or death. Ryobi service centre for assistance. Use unleaded petrol intended for motor vehicle use with an octane rating of 87 [(R + M)/2] or higher.
English SETTING BLADE HEIGHT WARNING See fi gure 3. Do not use this product if any parts on the packing list When shipped, the wheels on the mower are set to a low- are already assembled to your product when you unpack cutting position.
English FUEL AND REFUELLING To add engine oil: 1. Be sure mower is level and area around oil cap/dipstick WARNING is clean. 2. Remove the cap and seal from oil bottle. Always handle petrol with care; it is highly fl ammable. 3.
English WARNING WARNING When servicing, use only authorised replacement parts. Drain the fuel fi rst before tilting the mower to replace the Use of any other parts may create a hazard or cause blade. product damage. 1. Stop the engine and disconnect the spark plug wire. Allow blade to come to a complete stop.
English engine at least 10 minutes after adding stabilizer to WARNING allow the stabilizer to reach the carburetor. A leaking fuel cap is a fi re hazard and must be replaced immediately. WARNING The fuel cap contains a non-serviceable fi lter and a Do not store the lawn mower with petrol in the tank check valve.
English SPECIFICATIONS Engine 190cc OHV Drive system Push type No-load speed 2,800/min (RPM) Cutting path 556 mm Height adjustments 5 positions 19 mm−76 mm Wheel size 20.3 cm front, 20.3 cm rear Measured sound LwA 95.65 dB(A), K=1.2 dB power level Sound pressure LpA 81.4 dB(A), K=3 dB level...
TROUBLESHOOTING Problem Possible cause Solution Handle not in Handle positioned incorrectly. Check to be sure that lower part of handle is pushed correct position. fully back and snapped into proper position. Handle knobs not tightened. Tighten handle knobs. Mower is not No spark.
Page 12
4. For servicing, the product must be sent or presented to an RYOBI authorized service station listed for each country in the following list of service station addresses. In some countries your local RYOBI dealer undertakes to send the product to the RYOBI service organisation.
Techtronic Industries GmbH Max-Eyth-Strasse 10, D-71364 Winnenden, Germany Herewith we declare that the product Petrol Lawn Mower Model number: RLM1956MEB Serial number range: 91000502000001 - 91000502999999 is in conformity with the following European Directives and harmonised standards 2006/42/EC, 2004/108/EC, 2000/14/EC, 2005/88/EC, 2011/65/EU, EN 836:1997+A4:2011 Measured sound power level: 95.65 dB (A)
Need help?
Do you have a question about the RLM1956MEB and is the answer not in the manual?
Questions and answers