Installation - Kicker IX.5-SERIES Owner's Manual

Authorized KICKER Dealer:
Purchase Date:
Serial Number:
PERFORMANCE
RMS Power:
AMP1 & AMP2 channels driven
@ 14.4V, 4Ω stereo,  1% THD+N
@ 14.4V, 2Ω stereo,  1% THD+N
@ 14.4V, 4Ω mono,  1% THD+N
RMS Power:
SUBWOOFER channel driven
@ 14.4V, 4Ω mono,  1% THD+N
@ 14.4V, 2Ω mono,  1% THD+N
Length
Height
Width
Frequency Response ± 1dB
Signal-to-Noise Ratio
Input Sensitivity
Selectable Electronic Crossover
Bass Boost
Subsonic Filter
Maximum Effi ciency

INSTALLATION

Mounting: Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no items
behind the area where the screws will be driven. Choose a location that allows at least 4" (10cm) of open
ventilation for the amplifi er. If possible, mount the amplifi er in the climate-controlled passenger compartment. Drill
four holes using a 7/64" (3mm) bit and use the supplied #8 screws to mount the amplifi er. Use the IXSM or IXSK
mounting kits (sold separately) to stack IX amplifi ers.
2
65W x 4
125W x 4
250W x 2
250W x 1
500W x 1
11-3/8" (288mm)
2-3/16" (55mm)
7-7/8" (200mm)
20Hz–20kHz
>90dB, A-weighted, re: rated power
Low Level: 125mV–5V
High Level: 250mV–10V
Variable HI or OFF (bypass) | 50–200Hz, 12dB/octave
Variable low-pass | 50–200Hz, 24dB/octave (SUB)
Variable 0–18dB @ 40Hz
24dB/octave, fi xed at 25Hz
(2Ω)
>80%
IX AMPLIFIERS
IX.5-SERIES AMPLIFIERS Owner's Manual
IX1000.5
IXSM
sold separately