Kenwood KDC-MP825 Instruction Manual page 13

5
Select the Audio Control item for
adjustment
Press the [2] — [5] button.
Each time the [2] — [5] button is pressed the
adjustable audio items are switched among
ranges of all stage section's tables on the
following pages.
6
Adjust the Audio Control item
Press the [ ] or [
Each time the button is pressed the setting
switches as shown below.
• The Adjustment item can also be controlled by the
rotary volume knob. Refer to 'Rotary Volume knob
operation mode select'(page 14).
7
Exit Audio Control mode
Press the [6] button.
• The loudness setting can also be adjusted by pressing
the [4] button.
• * This mode is available only when 'Subwoofer Output'
(page 14) is ON.
1st section
[2] button
Adjustment Item Display
Bass level "Bass"
[3] button
Adjustment Item Display
Middle level "Middle"
[4] button
Adjustment Item Display
Treble level "Treble"
[5] button
Adjustment Item Display
Subwoofer level "SW Level"
] button.
Range
–8 — +8
Range
–8 — +8
Range
–8 — +8
Range
–15 — +15
2nd section
[2] button
Adjustment Item Display
Front/Rear High Pass Filter "HPF"
[3] button
Adjustment Item Display
Subwoofer Low Pass Filter "LPF SW"
[4] button
Adjustment Item Display
Loudness "LOUD"
[5] button
Adjustment Item Display
Balance "Balance"
Fader "Fader"
• When the Dual Zone System is ON, the setting for the
High Pass Filter is nullified.
3rd section
[2] button
Adjustment Item Display
Volume offset "V-Offset"
• Volume offset: Each source's volume can be set as a
difference from the basic volume.
Range
THRU/100/125/170 Hz
Range
50/80/120/THRU Hz
Range
ON/OFF
Range
L 15 — R 15
R 15 — F 15
Range
–8 — 0
13
|
English