29 UK-English.qx
6/22/99 12:14 PM
Operation
Note
With the S/RF-SWR-CALswitch
in the SWR position the meter
needle should ideally be as far
to the left as possible.
While still holding down the microphone
5
Anything over 3 is not accept-
button,set the S/RF-SWR-CAL switch to the
able. A slight antenna height
SWR position, to read the SWR reading.
adjustment (higher or lower)
may be required. Repeat
Repeat the same steps 2 to 5 on Channel 1
6
relcalibration steps.
and 40. This will check SWR for all channels.
To Receive
To Receive
Rotate the
1
The green RX/TX LED will be illuminated.
12
Page 12
On/Off Volume knob clockwise.
Selecting A Channel
Switch to
NOR to select desired channel.
1
S-Meter
Swings proportionately to strength of incoming
signal when receiving.
The
S/RF switch must be in the S/RF position
1
to read the meter.
Operation
Selecting A
Channel
Note
Switch to 9 or 19 for instant
access to these channels.
S-Meter
13