Kenwood TK-760G Service Manual page 14

TK-760G/ ( N
8-1. Enter to the Self Programming Mode
Remove D507 (Figure 3) from the TX-RX unit. Hold down
the [A] key and turn the power switch on. When enter the
self programming mode, "SELF" is displayed. The mode
changes autoically to Model Select Mode in about one sec-
ond, and set up radio type, radio band & channel type and
frequency version.
Note :
This mode (self programming mode) cannot be set when
it has been disabled with the FPU.
TX-RX unit B/2
Foil side
D505
5
IC505
8
14
) /762G/ ( N )
REALIGNMENT
IC502
50
51
4
1
Fig. 3
9. Channel Setting Mode
Each channel can be setup in its action mode by using
the panel keys.
• Pressing [MON] when "SELF" is diaplyed, sets channel
setting mode.
• Select an item set using [ ] then change the selection
with the [CH / ].
• The data displayed using [D/A] is stored in the memory
and then proceeds to the next item.
• Pressing [ ] proceeds to the next item without storing it
in the memory.
• Press [MON] to set the display to "SELF" and return to
reset (default) status.
The setup items for channel setting mode are listed be-
low.
No. Function Choices
Select 1~128 __1-__1._
channel __1-128._
Select 1~128 __1.-__1_
group 128.-__1_
1 RX Step STP__250
frequency 2.5kHz~1MHz STP___1M
Blank R. - - - - - - - [ ] : Frequency on/
100.0000~ R.150.0000 blank switching
550.0000MHz
2 RX Off - - - - - - - -
signalling QT 67.0~250.3Hz QT__67.0_
(EIA mode) QT_250.3_
QT 67.0~254.1Hz QT__67.0*
(0.1Hz step mode) QT_254.1* Inverse switching
DQT 000~777 DQT000N*
(Normal) DQT777N*
(1 step mode)
DQT 023~754 DQT023N_
(Normal) DQT754N_
(Standard table mode)
DQT 000~777 DQT000I*
(Inverse) DQT777I*
(1 step mode)
DQT 023~754 DQT023I_
(Inverse) DQT754I_
(Standard table mode)
3 TX Step STP__250
frequency 2.5kHz~1MHz STP___1M
Display Remarks
[ ] : Group selection/
Channel selection
change
Display when an item
is selected or when a
step is changed
(about 0.5 seconds)
[A] : Step change
5.0, 6.25kHz, 1MHz step
The right most dot
indicates 50Hz digit
(On=5, Off=0)
[ ] : Off/QT/DQT
switching
[A] : Mode switching
[SCN] : Normal/
Display when an item
is selected or when a
step is changed
(about 0.5 seconds)
[A] : Step change
5.0, 6.25kHz, 1MHz step