Installation; Before You Begin; General Information - Thermador WDC30J Installation Manual

Professional and masterpiece convection warming drawers
Hide thumbs Also See for WDC30J:
Table of Contents

Advertisement

Available languages

Available languages

Installation

Before you Begin

Tools and Parts Needed
Jig Saw with wood blade
Masking or Painter's tape
Phillips head screwdriver
Measuring tape
Drill with 1/8" bit
Work gloves
Items Included
3 – Phillips head screws, 3/4" (3.175 mm)
4 – Phillips head screws, 1/2" (12.70 mm)
(WDC30J / 36J models only)
1 – Stainless steel panel (WDC30J / 36J models only)
1 – Anti-tip bracket
1 – Installation Manual
1 – Use & Care Guide
CAUTION!
It is recommended to have two installers to
install warming drawer. Failure to do so may
result in property damage or personal injury.
CAUTION!
Never operate the warming drawer without a front panel
attached. You can attach a THERMADOR
or a custom front panel.
CAUTION!
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned
ON accidentally.
English 2
DO NOT lift the warming drawer by the door's handle, as
this may damage the door hinges and cause the door to
fit incorrectly.
Do not repair or replace any part of the appliance unless
specifically recommended in the manual. Improper
installation, service or maintenance can cause injury or
property damage. Refer to this manual for guidance. All
other servicing should be done by a qualified technician.

General Information

Power Requirements and Grounding
Circuit Specifications: 120V, 15A, 60Hz, 3-wire, grounded
outlet.
The outlet must be properly grounded in accordance with
all applicable codes.
It is the responsibility of the installer to comply with local
codes. If no local codes are applicable, wire in accordance
with the National Electrical Code, ANSI/NFPA 70 - latest
edition.
Electrical Location
The electrical outlet can be installed in the back wall
®
front panel
directly behind the warming drawer. A recessed power
receptacle must not exceed 5½ ft (1.7m) maximum
distance from the right side of the warming drawer cutout.
Installation clearances permit for the excess power cord to
be coiled behind the appliance.
DO NOT install this warming drawer in wet locations or
outdoors.
CAUTION!
WARNING!
Remove all tape and packaging before using the
appliance. Please, recycle the packaging
material, as all THERMADOR appliance
packaging material is recyclable. Never allow
children to play with packaging material.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wdc36jWdc30jsWdc30jpWdc36jp

Table of Contents