Advertisement
_____________________________________________________________________________
h. The top section does not require a screw. To secure the top section, hold
the section below it with one hand and firmly twist and pull the top section
out with your other hand until it is firmly locked in place.
NOTE: The antenna should now be fully extended and laying on the
ground and all sections (except the top section) should be
secured with the screws.
i. Now, let's retrieve the vertical element wire from the base tube. Rotate the
base tube until you see the wire exit hole – it is located on the opposite
side of the tube from the wire tabs.
j. Use the supplied hook tool to grab the wire and pull a small U-shaped
portion of the wire through the exit hole, as shown below.
Once you get a small U-shaped portion of the wire out of the exit hole, you
can twist the tool, if needed, to help retrieve the wire. Now STOP and
carefully remove the tool. Next, hold the top part of the wire firmly in one
hand while you use your other hand to pull the lower, loose end of the wire
out through the exit hole. Do not pull on the top part of the wire – just pull
on the lower, loose end!
________________________________________________________________________
S9v 31' Installation Guide
14
Advertisement
