Advertisement
_____________________________________________________________________________
4. Assemble the S9v. To assemble the S9v antenna:
a. Lay the S9v on the ground near the ground mount and unwind the vertical
element wire from the base tube. Now, "walk the wire" away from the
antenna base tube in a straight line. Don't pull unnecessarily on the wire –
the idea is to just un-roll the wire to its full length. Once the wire is
completely unrolled, pull small sections of the wire through your hands to
straighten the wire. NOTE: The wire does NOT have to be perfectly
straight, so don't spend a lot of time trying to straighten the wire!
b. Next, remove the TOP end cap. Do NOT remove the BOTTOM end cap
where the wire exits. Put the top cap in your pocket so that it will not be
lost in the grass.
________________________________________________________________________
S9v 31' Installation Guide
Pull wire straight out from
base tube until it is fully
extended along the ground
11
Advertisement
