Advertisement
_____________________________________________________________________________
c. Now we are ready to extend the antenna sections. The S9v should still be
laying flat on the ground. To extend the antenna, grab a section of the
wire near the bottom end cap and push the wire into the base tube. This
action should cause the top, thinnest section of the antenna (it has a cap
on its tip) to pop out of the top of the base tube. (If this doesn't work, pick-
up the base tube and shake it slightly while pointing the top part of the
tube downward.)
d. Gently pull the top, thinnest section straight out of the base tube (pull the
section, not the cap) until it catches and pulls the next, lower section out.
Gently twist the top section to lock it into the lower section. Now, pull the
lower section straight out until the next section appears. Gently twist and
lock the sections. Repeat this until you have extended all the sections
from the base tube.
NOTE: When the antenna is completely extended on the ground the
vertical element wire may disappear into the base tube - we
will retrieve it in a few steps.
________________________________________________________________________
S9v 31' Installation Guide
Grab top section
here (not the cap)
and pull straight out
to retrieve the next
section. Repeat until
all sections are
extended from the
base tube.
12
Advertisement
