Advertisement
_____________________________________________________________________________
e. All of the sections (except the top section) have been pre-drilled to accept
a stainless steel screw (9 needed; 10 provided). Starting at the bottom of
the antenna, grasp the base tube in one hand and twist and pull the
section above the base tube until you see a small black mark on the upper
section (the mark should appear above the seam between the two
sections). Twist the upper tube until the mark on the upper section aligns
with the pre-drilled screw hole in the lower base tube. At this point, the
pre-drilled holes in both sections should be aligned. For example:
f. Using a Phillips screwdriver, install TWO screws in the base tube (one on
each side). DO NOT OVER-TIGHTEN the screws. It is not necessary to
make the screws extremely tight.
Do NOT over-
tighten screws!
g. Install screws in the remaining fiberglass sections, working your way up
the antenna. (The base tube is the only section that requires two screws.)
________________________________________________________________________
S9v 31' Installation Guide
13
Advertisement
