General operation
Before Using
Exit of the Demonstration Mode
Turn off the demonstration mode when you use it
for the first time after installation.
1
Press the [VOL] knob to quit the demonstration
mode when the messages "CANCEL DEMO" and
"PRESS", "VOLUME KNOB" are displayed (approx.
15 seconds).
2
Turn the [VOL] knob to select "YES" and press the
[VOL] knob.
⁄
• The demonstration can be set or cancel using
<Demonstration Mode Setting> (page 18).
Common Operation
Power and source select
Turns the power ON by pressing the [SRC]
button.
Pressing [SRC] button each time switches
between sources.
Tuner ("TUNER") ➜ USB* or iPod* ("USB" or
"iPod") ➜ CD ("CD") ➜ Auxiliary input ("AUX") ➜
Standby ("STANDBY")
Keeping pressing the [SRC] button at least 1
second turns the power OFF.
⁄
• * Function is KDC-BT40U only.
• When connection of the iPod is recognized, the source
display changes from "USB" to "iPod".
• The source "CD" and "iPod" can be selected when each
source is ready to play.
Volume
Turning the [VOL] knob adjusts the sound
volume.
Function Setting Operation
The basic operating procedure for using this
function is described below. The individual function
items are covered in the operating procedures.
1
Select the source
Press the [SRC] button.
Function items vary from source to source. For a list
of the function items. Refer to <Function Item List>
(Page 30).
2
Enter Function Setting mode
Press the [VOL] knob for at least 1 second.
"FUNCTION" is displayed.
3
Select your desired function item
Turn the [VOL] knob and press it when the
desired item is displayed.
Repeat the operation until your desired function
item is selected.
⁄
Press the [
] button to return to the previous
item.
Example:
AUDIO CONTROL
BASS BOOST
DETAILED SET
DETAIL SET
SUPREME SET
DISP SELECT
SETTINGS
In this manual, the above selection is indicated as
Select "AUDIO CONTROL" ("AUDIO CTRL")
"DETAILED SET" ("DETAIL SET")
(" ") encloses a display appearing on the KDC-BT30.
It is shown only if it differs from the one appearing
on the KDC-BT40U.
4
Make a setting
Turn the [VOL] knob to select a setting value,
and then press the [VOL] knob.
5
Exit Function Setting mode
Press the [
] button for at least 1 second.
[VOL]
[VOL]
>
>
"SUPREME SET".
5
|
English