Connecting Wires To Terminals - Kenwood KDC-BT30 Instruction Manual

Connecting Wires to Terminals

KDC-BT30
Fuse (10A)
Wiring harness (Accessory1)
Mute control wire (Brown)
Steering remote control (Light Blue/Yellow)
Power control/Motor antenna
control wire (Blue/White)
Battery wire (Yellow)
Ignition wire (Red)
Connector A
8 6 4 2
7 5 3 1
8 6 4 2 Connector B
7 5 3 1
AUX input (Stereo)
Use the mini-plug cable which is
stereo type and does not have any
resistance.
FM/AM antenna input (JASO)
R L
Rear output/Sub Woofer output
Switches the preout between rear output ("REAR") and subwoofer
output ("SUB-W"). Refer to "SWITCH PREOUT"/("SWITCH PRE" ) of
<Initial Setting> (page 18).
If no connections are made, do not let the wire come out from the tab.
MUTE
REMOTE CONT
STEERING WHEEL
REMOTE INPUT
P.CONT
ANT. CONT
See next page
A–7 Pin (Red)
A–4 Pin (Yellow)
KDC-BT40U
Antenna Cord
To connect the Kenwood navigation system, consult your
navigation manual.
To use the steering wheel remote control feature, you
need to an exclusive remote adapter (not supplied)
matches your car is required.
Connect either to the power control terminal when using
the optional power amplifier, or to the antenna control
terminal in the vehicle.
USB connector
33
|
English