Blowing Operation; Maintenance - ArmorAll AA255 Operator's Manual

This Wet/Dry Vac has blowing capabilities only when the hose is inserted into the blowing port. To use the
blower feature follow the instructions listed.
WARNING:
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN CANADA,
CSAZ94.3) BEFORE USING BLOWER.
WARNING:
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING:
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE INHALED.
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Make sure the container is empty before using as a blower.
3. Remove hose from the vacuum port.
4. Insert the larger end of the hose into the blowing port on the back side of the power head. (fig.2)
5. Fit the desired attachment to the hose. (fig. 3)
6. Ensure the power switch is turned off and plug into the power supply. (fig.4)
7. Before turning on the vac, firmly hold loose end of the hose. Turn the motor on by flipping the switch to
the 'I' ON position. (fig.5)
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Disconnect the hose from the vacuum. (fig.2)
3. Undo the latches and remove the power head from the container. (fig.3)
4. Clear all dirt or debris from the container and hose. (fig.4)
5. Clean or replace the filters. (fig.5)
6. Check the hose, attachments, and power cord to verify that they have not been damaged.
IMPORTANT!
Clean or change the dust filter regularly for best performance. ALWAYS USE DUST
FILTER FOR DRY VACUUMING. If the machine is used with out the dust filter, the motor will burn out and
the warranty will be voided. Always keep spare filters on-hand.

BLOWING OPERATION

MAINTENANCE