Connecting Wires To Terminals - Kenwood KDC-5019 Instruction Manual

Connecting Wires to Terminals

If no connections are made, do not let the wire come out from the tab.
4 When using the optional power amplifier,
connect to its power control terminal.
5 Depending on what antenna you are using, connect
either to the control terminal of the motor antenna, or
to the power terminal for the booster amplifier of the
7 To car light control switch
Car fuse box
(Main fuse)
42
11 Rear right output (Red)
10 Rear left output (White)
13 Front right output (Red)
14 Front left output (White)
15 FM/AM antenna input
P.CONT
Power control wire (Blue/White)
16
ANT.
Motor antenna control wire (Blue)
CONT
film-type antenna.
17
ILLUMI
Dimmer control wire (Orange / White)
19
Ignition key
switch 41
Car fuse box
Ground wire (Black) - (To car chassis)
+ –
Battery
43
3
Wiring harness
(Accessory1)22
ACC 44
Ignition wire (Red) 46
Battery wire (Yellow) 47
45
48
— 24 —
Fuse (10A) 27
To KENWOOD disc changer/
DAB control input/
KPA-SD100/ KPA-HD100/
KPA-SS100 25
To connect these leads,
refer to the relevant
instruction manuals.
28
White/Black
To front left
speaker 29
FRONT • L
White
30
31
Gray/Black
To front right
speaker 32
FRONT • R
Gray
33
34
Green/Black
To rear left
speaker 35
REAR • L
Green
36
37
Purple/Black
To rear right
speaker 38
REAR • R
Purple
39
26