Kenwood KDC-5019 Instruction Manual page 29

If the following situations, consult your nearest service
center:
• Even though the disc changer is connected, the Disc Changer source is
not ON, with "AUX" showing in the display during the Changer Mode.
• Even though no device (KCA-S210A, CA-C1AX, KDC-CPS87, KDC-CX87,
KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected, the
Auxiliary input is entered when switching modes.
The messages shown below display your systems
condition.
Eject: No disc magazine has been loaded in the changer.
The disc magazine is not completely loaded.
➪
Load the disc magazine properly.
No CD in the unit.
➪
Insert the CD.
No Disc: No disc has been loaded in the disc magazine.
➪
Load a disc into the disc magazine.
TOC Error: No disc has been loaded in the disc magazine.
➪
Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-down. The CD
is scratched a lot.
➪
Clean the CD and load it correctly.
Blank DISC: Nothing has been recorded on the MD.
No Tr DISC: No tracks are recorded on the MD, although it has a
title.
E11
NO PANEL: The faceplate of the slave unit being connected to
this unit has been removed.
➪
Replace it.
E-77: The unit is malfunctioning for some reason.
➪
Press the reset button on the unit. If the "E-77"
code does not disappear, consult your nearest
service center.
Mecha Error: Something is wrong with the disc magazine. Or the
Hold Error:
E01
NO NAME:
E02
NO TITLE:
E04
NO TEXT:
Load:
E10
NO ACCESS: After setting it in the Disc Changer, DNPP was done
IN (Blink):
E30
E77
— 29 —
unit is malfunctioning for some reason.
➪
Check the disc magazine. And then press the reset
button on the unit. If the "Mecha Error" code does
not disappear, consult your nearest service center.
The protective circuit in the unit activates when the
temperature inside the automatic disc changer
exceeds 60°C (140°F), stopping all operation.
➪
Cool down the unit by opening the windows or
turning on the air conditioner. As the temperature
falls below 60°C (140°F), the disc will start playing
again.
Attempted to display DNPS during the CD play having
no disc names preset.
E51
Attempted to display the disc title or track title while
the MD having no MD title is being played.
• Attempted to display the disc text or track text
while the CD having no CD text is being played.
• Attempted to display text during reception of the
station that isn't sending text data.
Discs are being exchanged in the Disc changer.
without having it been played at least 1 time.
The CD player section is not operating properly.
E99
E0d
E53
E54
E55
E57
E58
E59