Group Control - Toshiba RAV-SM1103DT-A Installation Manual

Concealed Duct High Static Pressure

Group control

In case of group control for system of
multiple units
One remote controller can control maximum 8
indoor units as a group.
▼ In case of group control in single system
Outdoor unit Outdoor unit Outdoor unit Outdoor unit
Indoor unit Indoor unit
Remote controller
Finish of address setup by power-ON
• For wiring procedure and wiring method of the
individual line (Identical refrigerant line) system,
follow to "Electric work".
• Wiring between lines is performed in the
following procedure.
Connect the terminal block (A/B) of the indoor
unit connected with a remote controller to the
terminal blocks (A/B) of the indoor units of other
indoor units by wiring the inter-unit wire of the
remote controller.
• When the power supply has been turned on, the
automatic address setup starts and which
indicates that address is being set up flashes on
the display part. During setup of automatic
address, the remote controller operation is not
accepted.
Required time up to the finish of automatic
addressing is approx. 5 minutes.
NOTE
In some cases, it is necessary to change the
address manually after setup of the automatic
address according to the system configuration of
the group control.
Outdoor unit
Indoor unit Indoor unit Indoor unit
(Max. 8 units)
– 28 –
Installation Manual
EN
28-EN