Wire Connection - Toshiba RAV-SM1103DT-A Installation Manual

Concealed Duct High Static Pressure

Wire connection

REQUIREMENT
• Be sure to connect the wires matching the
terminal numbers. Incorrect connection
causes a trouble.
• Be sure to pass the wires through the bushing
of wiring connection port of the indoor unit.
• Remove the cover of the electric parts box by taking off the mounting screws (2 positions)
• Tighten the screws of the terminal block, and fix the wires with cord attached to the electric parts box.
(Do not apply tension to the connecting section of the terminal block.)
• Be sure to set a loop for the connecting wire of the storing part of the indoor unit electric parts;
otherwise the electric parts box cannot be drawn out in service time.
• Mount the cover of the electric parts box without pinching wires.
<Inner construction drawing of electric parts box>
P.C. board
Terminal board for remote
controller connection
Terminal board for
indoor/outdoor
connecting wire
Earth screw
Remote
controller wire
Cord clanp
Side D (Space: 8.5mm)
Side C (Space: 4mm)
Select side C or D for the power cable clamping position referring to the
following table according to the cable type and diameter.
* Cable clamp can be attached on either right or left side.
When twin system are connected, clamp two cables with one cable clamp.
Wire type Specification
Cabtyre cable 4-core stranded wire 2.5mm²
Cabtyre cable 4-core stranded wire 1.5mm²
– 22 –
• Keep a margin (Approx. 100mm) on a wire to
hang down the electric parts box at servicing,
etc.
• The low-voltage circuit is provided for the
remote controller. (Do not connect the high-
voltage circuit)
Fixing screw
Twin connecting terminal board
CAUTION
Not used in this time.
Power supply connector fixing
band for twin
Connecting wire
Cable clamping position
Side D
Side C
Installation Manual
Electric parts
cover
EN
22-EN