Table of Contents
Advertisement
Presser foot up and extra lift toggle
Presser foot down and pivot toggle
Press this button to start or stop the machine
without using the foot control. Press the button
once to start and press it again to stop.
Thread snips
Press to cut both needle and bobbin thread
immediately.
If pressing this button while sewing, the machine
will complete the stitch and cut the threads before
the needle moves to the start position of the next
stitch. Your machine ties off the thread, cuts the
needle and bobbin threads and raises the presser
foot and the needle.
The thread snips function can be programmed, see
page 4:10.
Note: Threads are cut automatically when buttonholes
are sewn with the Sensormatic buttonhole foot.
The presser foot will not raise after thread snips if
automatic presser foot lift has been deactivated in the
settings menu.
Thread snips performed by the machine can be cancelled
in the settings menu.
In embroidery mode the threads are cut and the presser
foot raised. The needle thread only cuts automatically at
and bobbin threads are cut automatically.
Start/stop
Reverse indicator
Action indicator
Reverse button
Reverse button
For permanent reverse, press the button once before
starting to sew. The reverse indicator will be lit
and the machine sews in reverse until you press
the button again to cancel. If you press the reverse
button while sewing, the machine sews in reverse
for as long as you keep the button pressed. The
reverse indicator is lit when the reverse button is
pressed.
Reverse is also used when sewing manual
buttonholes, darning stitches, programmed tie-off
end and tapering stitches.
Reverse indicator
The reverse indicator will be lit when pressing the
reverse button to sew in reverse. It is also lit while
sewing permanent reverse.
Action indicator
The action indicator is lit to indicate that an action
is to be done, for example performing tapering. The
indicator stays lit until the action is done.
Immediate tie-off
Stitch restart
Speed control
Needle up/down
Thread snips
3:7
Advertisement
Table of Contents
