Table of Contents
Advertisement
AE/LZB 119 1890 R1A
Radio Assembly
1.
Place the back cover down on a firm suface, battery
compartment side down.
2.
Ensure that the RF/weatherproof gasket is positioned
into the back cover groove correctly.
3.
Carefully mate the front cover with printed circuit
board onto the back cover, observing that the
RF/weatherproof gasket is not pinched or damaged as
the two parts mate.
4.
Turn unit over and install the six (6) screws into the
back cover. Note that the four (4) shorter screws are
used in the battery compartment area.
5.
Tighten screws securely (no more than 1.5 in-lb torque)
while observing that RF/weatherproof gasket between
front and rear covers is not pinched or damaged.
6.
Reinstall battery pack and antenna.
Volume Control Knob
1.
Install the knob over the volume control shaft and
tighten the hex set screw securely.
18
Advertisement
Table of Contents
