AE/LZB 119 1890 R1A
CAUTION
•
Do not carry the radio by the antenna. Do not
use chemical cleaners, spray or petroleum based
products. They may damage the radio housing.
PERSONALITY PROGRAMMING
The EDACS-2 PC Programmer (TQ-3373) version 8.0
or later is used to edit, read or write the personality to the
IPE radio. A personality is simply a computer file generated
(created) by the user of the EDACS-2 program.
computer file (or personality) is downloaded into the radio
and contains data that will direct certain operating
characteristics of the radio unit.
The
EDACS-2
communicates with the radio through the Troubleshoot Box
(item 1 in the equipment list). Figure provides a diagram of
Typical IPE-200 Radio
Alexander 4
Connector
KRY 101 1062
Test Cable
KRY 101 1612/52
14
PC
Programming
software
DB-9(M) to DB-9(F) Cable
KRY 101 1612/53
Figure 10 - Personality Programming Equipment Setup
the Equipment Setup required to PC Program the radio.
Refer to the PC Programming manual (TQ-3373) for
detailed software operating instruction.
Personality Programming Mode
The EDACS-2 PC Programmer cannot communicate
with the radio unless the radio is in the Programming Mode.
To place the IPE radio in Programming Mode:
1.
Connect as shown in Figure 10 with all switches on
Troubleshoot Box (KRY 101 1612) in down or OFF
position.
2.
Remove battery from IPE before programming.
3.
Set MASTER switch to ON position.
The
4. Turn on radio by pressing
5.
After self-test of radio press
<
6.
Press the
display.
M
7.
Press
again and observe that display reads SURE?.
DB-9
ON
Serial
Port
MASTER
OFF
12V
DB-15
OFF
Test
5V
Port
SERVICE AF PATH
ERICSSONUJ
KL
E
key.
M
key.
key until PERS PROG appears in the
Rear View Of
Computer
15 Volt
Wall Supply
KRY 101 1612/54
Power Input
+15 VOLTS
ON
PHONE
AF IN
BNC
ON
MODE 1
AF OUT
HANDSET
OFF
MODE 2
HOOK
DIGITAL
MODE
Handset
KRY1011612
Test