Basic Troubleshooting; Diagnostic Flash Codes - Pride Sonic Owner's Manual

X . B A S I C

DIAGNOSTIC FLASH CODES

NOTE: Your scooter will not run unless the flash code condition is resolved and the scooter has been
turned off then turned back on.
FLASH CODE
n n n n n
n n
n n n n
n n n n n
n n n n n n
What if all the systems on my Sonic seem to be “dead”?
n
n
n
n
n
AUTO SHUTOFF FEATURE
n
NOTE: Although the motor controller will be shut down by the auto shutoff feature, all activated lights will
remain on. For maximum battery life it is recommended that you turn off your lights or turn the key to the
off position.
n
n
T R O U B L E S H O O T I N G
CONDITION
Batteries are too low to operate the scooter
or the charger is operating.
Controller is hot; the scooter seems to be
losing power.
Wigwag fault; your throttle control levers
are not responding.
The manual freewheel lever is in the
(rearward) freewheel position.
Scooter is operating with the charger
attached.
SOLUTION
Charge batteries or unplug the off-board charger
power lead from the electrical outlet.
Shut down your scooter for a minimum of several
minutes to allow the controller to cool.
Call your authorized Pride provider for assistance.
Turn the key to the off position, then push the
manual freewheel lever to the (forward) drive
position, restart your scooter.
Unplug the off-board charger lead from the
scooter's charger power lead receptacle.