Sonos Bundle 150 Setup Manual page 16

8
Sonos Bundle 150 Setup Guide
• You may need aY-adapter audio cable (one3,5 mm stereo miniplug to dual RCA
male connectors) to connect the speakers to the audio outputs on the Zone-
Player. If your speakers have a male 3,5 mm stereo plug, you will need to attach
a female-to-female coupler between the speaker plug and the Y-adapter audio
cable.
Ifyou're connecting a ZonePlayer 120•••
Connect speakers to the ZonePlayer 120 by choosing one of the following options:
Speakers: Power
rating should be at
least 75W for 8
Ohm speakers and
at least 150W for 4
Ohm speakers.
Make sure the
Voltage switch on
the back of the
ZonePlayer is set to
the proper position
for your country
before applying
power
• If you are using speaker wire, use your finger to firmly push the spring-loaded
speaker posts inward to reveal the connection hole. Insert the stripped end of
the speaker wire into the hole, then release. Repeat for the other speaker
connections.
• If your speakers have banana connectors, you can insert the plugs
directly into the banana jacks on the back of the ZonePlayer
(available in North America only). Repeat for the other speaker
connections.
Note: Be sure to connect the red (
+ )
and black ( - ) terminals from each
speaker to the corresponding terminals on the ZonePlayer. Mismatching of
polarities will result in weak central sound, and a distorted sense of sound
direction.