To pause the tape
÷ Press the 2 or 3 key to restart playback.
To wind tape at high speed
1
To fast wind in
direction |
÷ Press the 7 key to stop fast winding.
Selection of reverse mode
∏
rev. mode
Each press switches the modes as follows.
1"""lit.... Both sides are played.
(The tape stops after recording
onto both sides.)
2Goes off.. Only one side is played back (re-
corded), and then the tape stops.
÷ Set the tape correctly as shown in the figure. Wrong tape
setting can cause trouble.
÷ Normal (TYPE I), high (TYPE II), or metal (TYPE IV) tape
selection is set automatically.
÷ Remove tape slack before loading.
8
¡
To fast wind in
direction \
To stop playback
÷ The tape direction lights red.
Selection of DOLBY NR
The Dolby NR system minimizes the hiss noise
heard when playing tape.
B
C
Each press switches the modes as follows.
1 "B" is lit ... Dolby B NR is used.
2 "C" is lit ... Dolby C NR is used.
3 "B" and "C" not lit ... Dolby NR is not used.
÷ Select the Dolby NR mode according to the recording
condition of the tape.
Transport direction indicators
The 2 and 3 indicators indicate the current direc-
tion in which the tape advances when playback or
recording is started automatically by the easy op-
eration function, etc. This direction is the direction
stored in memory when the tape was last stopped.
(To change the direction, press the key for the de-
sired playback direction, and then press the 7 key.)
Transport direction indicators
2
Hearing sound
R-SE9T/DP-SE9/X-SE9 (En)
7
(Noise Reduction)
Dolby NR
3
23