Kenwood DP-SE9 Instruction Manual page 11

Caution for Connection
When connections are to be made, make sure that
the power plug is not plugged into a wall AC outlet.
Connect the equipment as shown in the figures.
Optical
fiber cable
(Supplied
with DM-SE9)
1.In case an associated system component is connected, also read the instruction manual of the component.
2.Insert the optical-fiber cable straight into the connector until it clicks.
Notes Notes 3.Be sure to attach the protection cap when the connector is not used.
4.Be careful not to bend, coil or bundle the optical fiber cable.
SYSTEM
CONTROL
DIGITAL
OUTPUT
OPTICAL
R L
LINE OUTPUT
Audio cord (x2)
(Supplied with DM-SE9)
DIGITAL IN
OPTICAL
REC
IN
1
PLAY
OUT
2
R L
SYSTEM
CONTROL
Caution regarding placement
To maintain proper ventilation, be sure to leave a
space around the unit (from the largest outer dimen-
sions including projections) equal to, or greater than,
shown below.
top panel : 50cm
side panel : 10cm
rear panel : 10cm
Ventilation fan
The ventilation fan runs high-power reproduction.
To allow for proper ventilation, do not block the ven-
tilation fan.
DP-SE9
DM-SE9 (optional)
11
System connection
R-SE9T/DP-SE9/X-SE9 (En)