Setting The Tutti; Locking The Tutti; Restoring The Factory Tutti Setting; Melody Coupler - Rodgers 795 User Manual

‹ SETTING THE TUTTI:
1. Select the desired stops.
2. Press and hold the SET piston, and press the TUTTI piston. The Tutti is set.
‹ LOCKING THE TUTTI:
1. Press and hold the TUTTI piston for approximately five seconds until "TUTTI
UNLOCKED" appears in the Console Display.
2. While continuing to hold TUTTI, rotate the Alpha Dial either direction until the
Console Display reads "TUTTI LOCKED."
3. Release TUTTI. The Tutti is locked.
‹ RESTORING THE FACTORY TUTTI SETTING:
1. Press and hold the TUTTI piston for approximately five seconds.. The Console
Display reads "TUTTI LOCKED" or "TUTTI UNLOCKED". Change to
"UNLOCKED".
2. While continuing to hold TUTTI, press and hold SET for an additional five
seconds. The Console Display reads "TUTTI FACTORY DEFAULT".
3. Release both pistons.
The Melody Coupler (MELODY) is located on lighted reversible piston, and lights when
it is engaged.
When MELODY is lit, any selected stop or MIDI voice in the Swell division sounds from
the highest key being played on the Great manual. This allows a solo melody and an
accompaniment to be played on the same manual.
In its default setting, the Melody Coupler affects keys 25 through 61 on the Great manual.
The lower end of its range is programmable and may be extended down to key 13 or up to key
49.
Note: The Melody Coupler can also be set in General combination pistons.
‹ SETTING THE RANGE OF THE MELODY COUPLER:
1. Press and hold the SET piston, and press MELODY which begins flashing.
2. Release the SET piston.
3. While the Melody piston is flashing, press a key which corresponds to the lowest
note the range is to extend. Any note from key 13 to key 49 may be selected.
After the selected key has been pressed, the Melody Coupler turns off. Note: When
a key is pressed to set the range, no sound is heard even if stops are on, so no
disturbance is made if programming during a performance.

MELODY COUPLER

13