Table of Contents
Advertisement
Installing the FORMULA 8200 in the Rack
When mounting the switch in a rack, do not stack units directly on top
of one another.
1.
If the rubber feet are attached, remove them.
2.
Attach the mounting brackets to the side of the switch using the M4 x
8 mm screws provided (Figure 4).
Use only the M4 x 8 mm screws provided. Longer screws may contact
the internal components, damaging the unit.
3.
Align the holes in the mounting brackets to the holes in the rack
(Figure 5) and secure with the screws provided.
4.
Attach the power cord to the back of the switch. Then attach the other
end of the power cord to a grounded AC power outlet.
5.
Proceed to the section, "Attaching a Console to the Switch."
Figure 4: Attaching the Mounting Brackets
Figure 5: Rackmounting the Switch
FORMULA 8200 Fiber Switch Installation Guide
Caution
Caution
5
Advertisement
Table of Contents
Need help?
Do you have a question about the Formula 8200 and is the answer not in the manual?