Installing The User Interface Board - Whirlpool KDDC24RVS Technical Education

INSTALLING THE USER INTERFACE BOARD

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Figure 1
1. Locate the red and white LED lights
located on the user interface board,
see figure 1.
Figure 2
2. Locate the rectangular shaped holes in
the housing, see figure 2.
3. Align the LED's on the user interface
board and the slots in the housing.
4. Install the user interface board.
NOTE: Do not force the board into place. If
the LED's are aligned with the holes in the
housing the board will drop into place, see
figure 3.
5. Install the screws.
6. Install the insulation.
7. Attach the housing to the front cover.
4-5
Figure 3