Whirlpool KDDC24RVS Technical Education page 25

REMOVING THE SEPARATOR (continued)
Figure 5
5. Drop the evaporator cover down to
access the wiring harness connector
located in the top right hand corner,
see figure 5.
6. Remove the 2 screws on the cover plate
and remove, see figure 6.
7. Disconnect three wiring harnesses,
see figures 7 and 8.
NOTE: There are releases located on the
top of two of the connectors that have to be
depressed to remove the wire harness, see
figure 7.
8. With the three harnesses removed from
the block, the evaporator cover can be
pulled out to access the remaining harness.
9. Disconnect harness, see figure 9.
Figure 6
Figure 7
Figure 8
10. After disconnecting the wire harnesses,
the evaporator cover can be removed,
see figure 10.
4-9
Figure 9
Figure 10
Continued on the next page