Husky T-124C Owner's Manual And Assembly Manual page 25

25
play when pressing the center of short chain and ½" of play when
pressing the center of long chain is ideal.
5. After you have tightened the frame bolts, test the drive system
by cranking the front gear. Remember that you can only crank in
one direction (forward). Backward cranking engages the coaster
brake. If you notice excessive pull or chain jumping, check the
chain tension and make sure that coaster brake hub is centered
on the frame. Also check the rear axle sprocket to make sure it
lines up with the coaster brake sprocket.
STEP 2 - Mounting the Wheels
T-124C/244 rear axle has one "Drive Side" (Right) and one
"Freewheel Side" (Left). Both rear wheels use the same hubs and
are identical. You can use them on either side. Drive side of the
axle has a flange with 3 pins that fit into the rear wheel's hub.
To mount the drive side wheel, remove the axle nut "A" and
washer, push the wheel over the axle so that the 3 drive pins are
inserted with the matching holes on the hub. See the picture.
Replace the washer and tighten the axle nut.
Drive Side Pin