Tools Needed - Husky T-124C Owner's Manual And Assembly Manual

TOOLS NEEDED

1. 10, 13, 14, 15, and 22 mm box wrench
2. 10, 13, 14, 15, and 22 mm open end wrench
3. Phillips and flat-head screwdriver
4. Wire cutter
5. 4, 5 and 6mm Allen Wrench
6. Bicycle Pump
There are 4 basic steps in assembly. They are:
STEP 1 - Connecting front and rear sections of the frame,
STEP 2 - Installing the wheels and fenders,
STEP 3 - Installing saddle, handlebar, and pedals, and
STEP 4 - Finishing work and test ride.
BEFORE YOU BEGIN THE ASSEMBLY
1. Remove the components and parts from both boxes.
2. Identify the components and parts and check against the
packing list on the next page.
3. Unpack the small parts bag, separating the bolts, nuts and
washers and grouping them by size.
4. Set the following components aside for steps 3 and 4:
Saddle
Seat Post
Pedals
Handlebar and grips
Brake lever and cable
Chain guard
Reflectors
Rear Hub Caps
TO PREVENT DENT OR SCRATCH TO PAINTED PARTS, DO
NOT REMOVE PROTECTIVE PADING AND WRAPS
UNTIL AFTER THE ASSEMBLY IS COMPLETE.
PACKING LIST
19