Installation Guide
Wallplate installation
1. Separate wall plate from thermostat.
Grasp top and bottom of wallplate
and pull to remove from thennostat.
2. Mount wall plate as shown below.
Drill 3/16" holes for drywall.
Drill
7/32"
holes for plaster.
Must be installed by a trained, experienced technician
• Read these instructions carefully. Failure to folloW these instructions
can damage the product or cause a hazardous condition •.
CAUTION: ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect power before
beginning installation.
MERCURY NOTICE
If this product is replacing a control that contains mercury in a sealed tube, do not
place the old control in the trash. Contact your local waste management authority for
instructions regarding recycling and proper disposal.
2