Auto-Coding Function - MHC Medical Products EasyTouch HealthPro User Manual

Setting Your Meter, Cont.
Days for Avg. Alarm On/Off
After pressing and After pressing and
releasing either or releasing either
buttons to set the buttons to turn the
number of days, alarm on/o , con rm
con rm with . with .
Alarm
After programming the
number of desired alarms
(5 alarms possible),
con rm with .
IMPORTANT:
1. Your EasyTouch® HealthPro™ Meter is pre-set to mg/dL as test unit.
If you nd out that the meter is not set to mg/dL, please contact
MHC Customer Support at (877) 358-4342 immediately.
2. The correct units of the measurement in U.S. are mg/dL.
3. Without setting the date properly, the average glucose level and the
results in memory will not show proper values. It is recommended to set
the meter before use immediately after new batteries are installed.
4. You can't test your blood glucose in the setting mode.
5. To turn the meter o during the setup, press
14
Alarm Time
After pressing and
or releasing either or
buttons to set the alarm
hour and minute,
con rm with .
for at least 5 seconds.

Auto-coding Function

1. The EasyTouch® HealthPro™ has an automatic
code recognition function.
2. The code number on the glucose meter is set
automatically and should match the code on
your test strip vial.
CAUTION:
1. Do not bend the glucose test strip. Bending could cause automatic
code recognition failure.
2. If the code recognition label is damaged, the code recognition may fail.
Please check the code number on the LCD window with the code
number on the test strip.
15