4.Reset Factory Defaults; 5.Scheduling Enable; 6.Smart Recovery Enable; Fan Coil - Bryant Evolution Connex SYSTXBBECW01-A Installation Instructions Manual

6.3.1.4. Reset factory defaults
This option allows the installer to reset certain factory parameters. After the
selections are made, touch SAVE.
Program Schedule: Reset back to pre- - programmed time and temperature.
S
User Settings: Reset user settings back to pre- - programmed values.
S
Install Settings: Reset installation settings back to pre- - programmed values.
S
Last 10 Faults: Reset the last 10 system faults under the Service menu.
S
6.3.1.5. Scheduling Enable
This option lets the installer allow programming features. After the selection is
made, touch SAVE.
Scheduling: On or Off
S
Default = On
d
6.3.1.6. Smart Recovery Enable
Applies to programmable operation only. Will start recovery 90 minutes prior to
schedule change in both heating and cooling mode. After the selection is made,
touch SAVE.
Smart Recovery: On or Off
S
Default = On
d
NOTE: The "Temperature Units Display" set- - up section has been moved to the
Homeowner Screens. See the Owner's Manual for more information.
6.3.2.

Fan Coil

First touch SETUP, then touch FAN COIL to set up the parameters for the fan coil
unit.
29