Electrical Adjustment Instructions - Philips 19PFL3504D/F7 Service Manual

ELECTRICAL ADJUSTMENT INSTRUCTIONS

General Note: "CBA" is abbreviation for
"Circuit Board Assembly."
Note: Electrical adjustments are required after
replacing circuit components and certain
mechanical parts. It is important to perform
these adjustments only after all repairs and
replacements have been completed.
Also, do not attempt these adjustments unless
the proper equipment is available.
Test Equipment Required
1. NTSC Pattern Generator (Color Bar W/White
Window, Red Color, Dot Pattern, Gray Scale,
Monoscope, Multi-Burst)
2. Remote control unit
3. Color Analyzer
How to make the Service remote
control unit:
1. Prepare the MAGNAVOX remote control unit.
(Part No. NF800UD or NF802UD)
2. Cut "A" portion of the attached remote control unit
as shown in Fig. 1.
service button
(There is a button under the plastic housing.)
A
How to set up the service mode:
Service mode:
1. Use the service remote control unit.
2. Turn the power on.
3. Press the service button on the service remote
control unit. The following screen appears.
" * " differs depending on the models.
Code :
Pin code :
MIPS :
Tuner :
Safety :
Fig. 2
5-1
***********-***
**-***-**-*****-***
Push 0key
****-*****-****
safety_Non
FL9.1PEA