Rear Roof Flap - PEUGEOT PARTNER Tepee Handbook

Access

REAR ROOF FLAP

This rear roof flap is only compatible
with side-hinged rear doors.
To open the rear roof flap:
- raise the black paddle of the toggle,
- relieve the toggle by pressing the
rear roof flap (downwards) then
release the hook,
- lift the rear roof flap,
- pass the point of resistance to
secure the rear roof flap using the
support stays.
Never drive without the stays in place.
To close the rear roof flap:
- check that the support bar is
secured correctly,
- lower the rear roof flap,
- while pressing the rear roof flap
(downwards), take hold of the two
loops of the spring then place the
hook in its housing,
- lower the black paddle to secure
the rear roof flap.
Securing the rear roof flap places it on
the seal correctly and ensures sealing
without noise.
Support bar
A support bar is provided for
transporting long loads, after opening
the rear roof flap.
Fold back the support bar by lifting the
lever.
guide it to the door pillar.
Support the long loads to be
transported, lift them and reposition the
support bar with one hand.
ensure that it is secured correctly by
pressing the handle downwards past
the point of resistance and secure the
loads firmly.
the side supports can be used as
hooking points.
Never attach any load to the rear roof
flap.
the rear bumper has been
reinforced to serve as a footrest
when entering the vehicle.
Never drive without the support bar in
place.
the rear doors only lock when the
support bar is installed.
When the rear roof flap is open, take
care when driving where height is
restricted.
Never rest loads directly on the rear
doors.
Comply with the usual indications, to
warn other drivers.
Reserve the use of the rear roof flap
for short journeys.