Table of Contents
Advertisement
Initial Camera Settings
-
RAISE the camera flash. This must be done before placing camera in
housing. Set Flash to "On
-
Insert a fully charged battery. Due to the power required to operate the
camera and LCD screen, start each dive with a fully charged camera
battery.
-
Move Mode Switch to "
-
In FUNC./SET:
Set Light Metering to "
-
Set White Balance to Auto "AWB." For best results, set to Custom "
and reset for each working depth.
-
Set ISO to "200."
-
Set Shooting Mode to "P" Program.
-
Set Image Recording Size to "L" 16M and Compression to "S" Superfine.
-
Set Movie Quality to "FHD."
-
In MENU Shooting Settings:
-
Set AF Frame to "Center" and Servo AF to "Off."
-
Set Continuous AF to "On."
-
Set AF-assist beam to "Off." A strobe focusing light is recommended to
assist AF underwater.
-
In the Flash Settings menu, set Red-Eye Corr. and Red-Eye Lamp
to "Off."
-
Set Review to "8 Seconds."
-
Set Blink Detection and Grid Lines to "Off." Set IS Mode to "Continuous."
-
In MENU Camera Settings:
-
Set Date/Time and Time Zone. Set ECO Mode to "Off."
-
In Power Saving, set Auto Power Down to "Off"; Display Off to "3 min."
-
Insert and Format an SCHD memory card.
Note: Enable Macro
overexposure occurs, back away from the subject and zoom in, and/or
use "-"
exposure compensation.
*
Camera functions not mentioned should be set to user's desired setting.
4
(before placing camera in housing)
Flash always fires."
" setting.
Center Weighted Avg."
mode when shooting close-up subjects. If
"
Advertisement
Table of Contents
