Advertisement
ASSEMBLY STEP 4
SECURING THE GAS LINE
HARDWARE BAG
HARDWARE
Using the Zip Tie, secure the Hose to underside of the Control Panel.
1.
2.
Tighten the zip tie so that there is no slack remaining. DO NOT over-tighten the
Zip Tie to help prevent the hose from coming into contact with the hot Burner
Chamber. OVER-TIGHTENING may restrict gas flow and could damage the
gas line.
3.
Inspect the installation underneath the Smoker to ensure that the Hose is not
rubbing any portion of the Burner Chamber.
4.
Carefully turn the Smoker upright onto its Legs.
ASSEMBLY STEP 5
DAMPER PLATE INSTALLATION
LOCATE THESE PARTS
3 DAMPER
PLATES
HARDWARE
HARDWARE BAG
3 NUTS
3 BOLTS
3 LOCK WASHERS
1.
Set one Damper Plate on top of the Cabinet and line it up with the
corresponding "butterfly" holes.
FIGURE 11
2.
Insert a Bolt from the top through the center hole.
3.
From the bottom side, place a Lock Washer and Nut on the Bolt.
4.
Thread the Nut just tight enough to keep the Damper Plate snug, it should be
able to rotate with little resistance.
5.
Repeat steps 1-4 on the other 2 sides with the Dampers Plates.
F
HVR
HOSE
ZIP TIE
CONTROL
PANEL
BURNER
CHAMBER
FIGURE 10
TOOLS NEEDED
PHILLIPS
HEAD
SCREWDRIVER
B
3/8" WRENCH
"BUTTERFLY"
BOLT
DAMPER
CABINET
PANEL
LOCK WASHER
NUT
-8-
After all connections are completed, check all connections and fittings for leaks with a soap solution.
.
With all valves closed, apply the leak check solution (50/50 mix of dish washing detergent and water)
to all gas carrying connections and fittings.
FIGURE 10
.
Open tank valve.
.
Presence of bubbles at areas of wet solution indicates a gas leak.
.
If Leaks are detected or you smell or hear gas, IMMEDIATELY shut off the valve and repair the
leak or replace the defective part. Do not use the Smoker until all leaks are corrected!
.
When setting up the smoker and tank, it is recommended to have the tank and smoker on a line perpendicular to the wind direction.
.
The gas hose/regulator assembly should be totally extended to the maximum distance so that the hose is straight and the tank is as
far from the smoker as it can be.
.
LP tanks are intended for operation in the upright position only.
.
Care should be taken to protect the fuel supply hose from damage from either foot or vehicle traffic.
.
If the appliance is not in use, the gas must be turned off at the supply cylinder and the cylinder should be disconnected from the
appliance.
.
Storage of the Smoker indoors is only permissible if the cylinder is disconnected and removed from the Smoker.
FIGURE 11
HOLES IN
CABINET
WARNING!
Be sure to follow ALL SAFETY
WARNINGS and precautions that are
contained in this instruction manual
before using this Smoker!
NEVER leave this appliance unattended!
The Smoker becomes EXTREMELY HOT!
When the Smoker is not in use, the gas
MUST BE TURNED OFF at the supply
cylinder.
CHECK FOR GAS LEAKS!
SET-UP TIPS
-13-
Advertisement
