Advertisement
ASSEMBLY STEP 8
WATER BOWL INSTALLATION
LOCATE THESE PARTS
WATER
BOWL
30" MODEL HAS 3 RACKS
36" MODEL HAS 4 RACKS
48" MODEL HAS 6 RACKS
Slide the Water Bowl into the lowest Rack position.
1.
2.
Insert the Cooking Racks into the remaining Rack positions as desired; however,
do not insert a Grid directly over the Water Bowl - the Water Bowl will restrict
heat distribution. For best results, the Rack wires should run front to back.
3.
Re-mount the Door Panel by sliding the Door's hinge pins into the Cabinet's
hinge seats.
FIGURE 14
ASSEMBLY STEP 9
HANDLE INSTALLATION
D
HARDWARE & PARTS
TOOLS NEEDED
DOOR
PHILLIPS
HANDLE
HEAD
Includes Spring & Washer
SCREWDRIVER
Slide the washer onto the end of the Door Handle, followed by the Spring.
1.
2.
Feed the Door Handle into the hole through the front of the Door Panel.
3.
From the back side of the Door Panel, insert the Mounting Plate over the end
of the Door Handle.
FIGURE 16
4.
With Lock Washers placed on the Bolts, insert the Bolts through the Mounting
Plate, into the pre-threaded mounts and firmly tighten the Bolts.
Repeat steps 1-4 for the 48" Smoker, as it will
have 2 Handles to install.
CABINET
COOKING
COOKING
RACKS
RACKS
Door
FIGURE 14
WATER
BOWL
FIGURE 15
FIGURE 16
DOOR
HANDLE
DOOR
PANEL
-10-
FIGURE 14
HARDWARE
NUT
WASHER
1.
Remove the Nut from the back of the Temperature Gauge and insert
the Temperature Gauge into the Door Panel.
Temperature Gauge numbers are positioned right side up.
2.
From the back side of the Door Panel, place the Washer on, then
thread the Nut onto the Temperature Gauge.
3.
Tighten the Nut firmly, but do not over tighten.
LOCATE THESE PARTS
FIGURE 15
NAMEPLATE
FIGURE 16
LOCATE THESE PARTS
S-HOOK
ASSEMBLY STEP 10
HEAT INDICATOR INSTALLATION
E
HARDWARE BAG
TOOLS NEEDED
1/2" WRENCH
TEMPERATURE
GAUGE
NOTE: This Nut is
already threaded
onto the Temperature
Gauge and must be
removed for assembly.
Make sure the
FIGURE 17
FIGURE 18
ASSEMBLY STEP 11
NAMEPLATE INSTALLATION
1.
Insert the Name Plate mounts through
the mounting holes in the front of the
Door Panel.
FIGURE 19
2.
From the inside of the Door Panel,
securely attach the Push Nuts to the
Name Plate mounts.
2 PUSH NUTS
ASSEMBLY STEP 12
SECURING THE HVR
1.
Place one end of the S-Hook around
F
the HVR neck.
HARDWARE BAG
FIGURE 20
2.
When an LP tank is not attached to the
Smoker, use the S-Hook to hang the
HVR from the Carry Handle on the
side of the Smoker. This will help
prevent dirt and other particles
from plugging the end of the HVR.
ASSEMBLY IS NOW COMPLETE!
Please follow all instructions and
safeguards on the following pages for
connecting the LP tank.
-11-
FIGURE 17
FIGURE 18
FIGURE 19
FIGURE 20
Advertisement
