Thane Housewares KB-6622V User Manual page 11

DUSTER
Make sure that the H2O MOP X5™ is unplugged.
1) Fill the Water Tank with water. Please refer to
the "HOW TO USE THE H2O MOP X5™" section
in this manual.
2) Install the Coral Cloth onto the Duster frame
and attach the Duster to the Extension Hose
as described in the "How To Assemble the
Optional Accessories" section in this manual.
3) Select one of the following Steam Regulator
positions: 1 – Low, 2 – Medium or 3 – High
Do not use 4 - Hot Spray steam setting when using the Duster.
You can change the Steam Regulator position and change the steam output
while operating the H2O MOP X5™.
4) Follow Step 3 described in the "How To Use the Hand-Hand Steamer"
section in this manual.
5) Hold the Hand-Held Steamer in one hand and grasp the handle grip on the
Extension Hose with the other hand as illustrated above.
6) Slowly pass over surface to be cleaned. The absorbent Coral Cloth picks up the
dirt loosened by the steam. Keep a towel handy and wipe away any excess water
that may accumulate.
!
CAUTION
Pulling on the Extension Hose with excessive force will damage it, possibly resulting
in a steam leak.
!
WARNING
DANGER OF SCALDING
Do not touch the Duster/Coral Cloth during usage, as these components
can get extremely hot.
Keep the Extension Hose away from your body and avoid touching the
hose as it can get hot.
7) When the Hand-Held Steamer stops emitting steam, simply turn off and unplug the
unit, refill the Water Tank and continue cleaning.
USER'S GUIDE
25
Insert the Power Supply Cord into the
Cord Holder located at the top of the
Extension Handle as illustrated in Fig. 4c and
then insert Power Supply Cord into the
Upper Cord Wrap as illustrated in Fig. 4d.
5) Place the Mircofiber Cloth on the
bottom of the Mop Head and make sure
all the loops on the cloth are
aligned with the gripping hooks
on the bottom of the Mop Head (Refer
to Fig. 5a), then press the cloth against the Mop Head so the loops on the
cloth catch the gripping strips on the Mop Head and hold the pieces together.
6) When using the H2O MOP X5™
on carpet surfaces: Place the Mop Head,
with Microfiber Cloth in place, on top of the
carpet glider as illustrated in Fig. 6a. Do not
attempt to use the H2O MOP X5™ unit
on carpet/rug surfaces without the carpet
glider in place.
!
NOTICE
Never use the carpet glider on surfaces
that are prone to scratching.
!
CAUTION
Never assemble or remove the accessories while the unit is in operation.
USER'S GUIDE
4c
4d
5a 5b
6b
6a
10