Table of Contents
Advertisement
DIRECT OPERATION
Select COMPUTER mode by pressing the MODE button on the Top
Control or the COMPUTER button on the Remote Control Unit.
MENU OPERATION
Press the MENU button and the ON-SCREEN MENU will appear.
Press the POINT LEFT/RIGHT buttons to select Computer and press
the SELECT button.
CURRENT MODE DISPLAY
When selecting the Computer Mode, the Current Mode display
appears. It shows the information of the computer of the mode
selected.
This projector automatically tunes to most different types of
computer based on VGA, SVGA or XGA (refer to "COMPATIBLE
COMPUTER SPECIFICATION" on page 23). When selecting Computer,
this projector automatically tunes to the incoming signal and projectors
the proper image without any special setting. (Setting of the Computer
System may be required when connecting some computers.)
Note : The projector may provides the messages below.
Go to PC adj. The projector cannot discriminate or detect the
input signal from the computer. Adjust and set the
computer system manually. (Refer to page 24.)
No signal
There is no signal input from the computer.
Make sure the connection of the computer
and the projector is set correctly.
(Refer to TROUBLESHOOTING on page 35.)
SELECT COMPUTER MODE MANUALLY
To set the Computer system manually, select the mode on the ON-
SCREEN MENU.
1
Press the MENU button and the ON-SCREEN MENU will appear.
Press the POINT LEFT/RIGHT buttons to select SYSTEM and
press the SELECT button. Another dialog box COMPUTER
SYSTEM Menu will appear.
2
Press the POINT DOWN button and a red-arrow icon will
appear. Move the arrow to the system that you want to set,
and then press SELECT button.
LC-NB2UW
22
Advertisement
Table of Contents
